Steer Assembly Components - JLG 1932RS/6RS Service And Maintenance Manual

3.15 STEER ASSEMBLY COMPONENTS

NOTE: Coat all pins with a light coat of molypaste before assembly. Pack inner and outer spindle bearings with multi-purpose grease
(MPG) before assembly. Do not overtighten spindle bearing nut. Replace spindle seal if worn, damaged, or leaking.
1. Install the bearing with the flange surface on top of the spindle arm.
2. Assemble the spindle kingpin attach, banjo pin hardware, in the frame hole towards the front of the machine.
3. Install cylinder to frame attach pin with cotter pin hole on top.
3121273
3
1
Figure 3-40. 1932RS/6RS - Steer Assembly
SECTION 3 - CHASSIS & SCISSOR ARMS
2
2
1
3-37