Platform Control Station; Installation/Removal; Control Station Harness Installation To Scissor Arms; Control Station Disassembly - JLG 1932RS/6RS Service And Maintenance Manual

SECTION 3 - CHASSIS & SCISSOR ARMS

3.19 PLATFORM CONTROL STATION

POWER MACHINE DOWN AT THE GROUND CONTROL STATION BEFORE DISCON-
NECTING THE PLATFORM CONTROL STATION.

Installation/Removal

1. Disconnect the platform control station harness at the
connector below the control station mount.
2. Remove the pin securing the control station to the plat-
form station mount, swing and lift to remove control
station from the machine.
Figure 3-58. Platform Control Station Installation
1. Harness Connector
2. Mounting Pin
3. To install, reverse steps 1 and 2 above.
3-56
3
2
1
3. Lift and Remove

Control Station Harness Installation to Scissor Arms

Below are a few notes for positioning and securing the
platform control station harness to the scissor arms when
installing or removing the harness on the machine.
• Orange and yellow marker tape strips are located on the
platform harness to assist in installation.
• At every yellow marker tape, secure the harness to the nuts
welded on the arms using wire ties.
• At every orange marker tape, secure the harness to the
cable carrier using wire ties.
• If necessary, additional wire ties should be used to firmly
attach the harness to the machine.

Control Station Disassembly

1. Place the platform control station assembly on a suit-
able work bench.
2. Remove the main body from the mount, by removing
the long through bolt, cap-nut and washers (item 1) and
the two (2) bolts and nuts (item 2) along the rear edge.
1
Figure 3-59. Platform Control Station Disassembly
1. Through Bolt, Cap-nut and
Washers
1
2
2. Rear Edge Bolts and Nuts
3121273