Platform Cable (3248Rs/10Rs) - Sheet 4 Of 4 - JLG 1932RS/6RS Service And Maintenance Manual

SECTION 3 - CHASSIS & SCISSOR ARMS
YELLOW MARKER TAPE
SECURE HARNESS TO THE
PLATFORM BY HOSE
CLAMP
YELLOW MARKER TAPE
SECURE HARNESS TO THE ARMS
BY INSERTING TIE STRAP,
THROUGH THE WELD NUTS
ALONG THE ARM STACK, 6X
YELLOW MARKER TAPE
SECURE HARNESS TO THE ARMS
BY INSERTING TIE STRAP,
THROUGH THE WELD NUTS
ALONG THE ARM STACK, 3X
YELLOW MARKER TAPE
SECURE HARNESS TO THE ARMS
BY INSERTING TIE STRAP,
THROUGH THE WELD NUTS
ALONG THE ARM STACK, 5X
APPROXIMATELY 236MM
ORANGE TAPE MARK
SECURE CABLE HARNESS
ALONG SIDE OF CYLINDER
UNTIL REACHING THE
ORANGE MARKER TAPE
ROUTE CABLE THROUGH
THE ROD AND SECURE TIE STRAP
ROUTE CABLE AROUND
CROSS TUBE
NOTICE: ROUTE IN A
CLOCKWISE DIRECTION
ROUTE CABLE THROUGH
FRAME AND TOP SHIELD
OPENING
NOTES:
1. ORANGE AND YELLOW MARKER TAPE STRIPS ARE LOCATED ON PLATFORM HARNESS TO ASSIST IN INSTALLATION.
2. AT EVERY YELLOW MARKER, SECURE THE HARNESS TO THE NUTS WELDED ON THE ARMS USING TIE STRAP.
UNLESS OTHERWISE SPECIFIED
3. AT EVERY ORANGE MARKER, SECURE THE HARNESS TO THE CABLE CARRIER USING WIRE TIE STRAP.
4. ADDITIONAL TIE STRAPS SHOULD BE USED TO FIRMLY ATTACH THE HARNESS TO THE MACHINE.
3-46
Figure 3-48. Platform cable (3248RS/10RS) - Sheet 2 of 4
DO NOT ROUTE HARNESS ON
THIS ROD
ORANGE MARKER TAPE
NOTICE: USE NOTCHES TO
LOCATE TIE STRAPS TO CABLE
CARRIER, 4X
ORANGE MARKER TAPE
NOTICE: USE NOTCHES TO
LOCATE TIE STRAPS TO CABLE
CARRIER, 4X
ORANGE MARKER TAPE
NOTICE: USE NOTCHES TO
LOCATE TIE STRAPS TO CABLE
CARRIER, 4X
YELLOW MARKER TAPE
SECURE HARNESS TO THE
ARMS BY INSERTING TIE STRAP,
THROUGH THE WELD NUTS
ALONG THE ARM STACK, 3X
FIRST ORANGE TAPE MARK
(BEGINS ON THIRD HOOK)
ROUTE CABLE AROUND
ARM STACK TO CYLINDER
NOTICE: ROUTE FROM
OUTSIDE TO INSDIE OF ARM
STACK
1001196746-B
MAF03370
3121273