Kaba 5402 Series Technical Manual page 82

Sargent
Retrofitting Sargent 7, 8 and 9 Line grade 1 knobs
1) With spanner wrench, loosen inside rose and unscrew outside rose com plete ly.
rose unscrewed
5) Pry up nylon ring and
remove knob collar.
7) Unscrew spindle from knob. Slowly separate knob
and spindle. Observe order of parts and save them,
including the roll pin.
Section 5 - 9
knob retainer spring visible through hole in aligner tube
aligner tube
2) Lock must be unlocked (outside knob free).
If storeroom function, remove inside knob first per
step 3. For other single cylinder functions, it is not
necessary to remove inside knob.
3) Rotate knob and until knob retainer spring is visible in any
hole threaded shank of aligner tube.
4) Depress knob retainer spring with small screw driv er. Pull
out on knob and rotate back to rest position. Pull knob out
of aligner tube.
8) Replace cylinder with Peaks Global
5400-xx-1008. Reverse steps to
reassemble. Do not re as sem ble with
key in cylinder.
6) Drive roll pin com plete ly into knob
with / " punch and mallet.
3
32