Kaba 5402 Series Technical Manual page 26

Key-In-Knob Cylinders - 5400 Series
SARGENT 10* Line levers, 2000 exit device trim
5400-xx-1095 uncombinated and use:
6500* Line,6 Line grade 2 knobs, except Ball
4700-00-4008 neoprene washer
1590-80-2000 SD/3A tailpiece, vertical
3450-80-2003 spacing washer
*10 Line, 6500: remove Sargent nylon or plastic spindle bushing and place washer
#4700-00-4008 over tailpiece before installing cylinder.
5400-xx-1010 uncombinated and use:
SARGENT 6 Line grade 2 Ball knobs
4700-80-2001 SA/3B tailpiece, vertical
3400-00-2009 spacing washer
5400-xx-1099 uncombinated and use:
SARGENT 5500 Line imported grade 2 knobs
4700-80-2001 SA/3B tailpiece, horizontal
3450-80-2003 spacing washer
5400-xx-1008 uncombinated and use:
SARGENT 7, 8 & 9 Line grade 1 knobs
3400-00-5108 adapter assembly
3400-00-2009 security bushing
5400-xx-1099 uncombinated and use:
SARGENT 465, 485, 486 single cylinder deadlocks
3450-00-2000 lost motion tailpiece
3450-80-2004 timing washer
Section 2 - 15
SD/3A
SA/3B
SA/3B
security
bushing
Roll pin should
protrude from this side
"95" plug & shell
with small diameter
plug face
large diameter
plug requires
J or K series
bottom pins
"06" plug & shell
"99"plug & shell
large diameter
plug requires
J or K series
bottom pins
small diameter
plug face required
"99" plug & shell
large diameter
plug requires
J or K series
bottom pins