Tools Required ..............3 " installation procedure for the E-Plex 5x63, 5x64, 5x68 and 5x69 1 American Steel Mortise (ASM) Mortise locks. These instructions pertain Exploded Install Parts .
These instructions are designed for use by maintenance professionals or lock installers who are familiar with common safety practices and competent to perform the steps described. Kaba Access Control is not responsible for damage, injury or malfunction due to incorrect installation.
B-6 Prepare the cutout for the mortise in the edge of the door using a mortis- B. DOOR PREPARATION ing machine, router and chisel (for dimensions, refer to template). Ensure If using the installation jig to prepare the door, refer Door clearance is provided for moving latch parts as indicated on the template.
C-3 Drill pilot holes for the strike mounting screws. E. INSTALLING INSIDE UNIT ASSEMBLY Mortise the door frame for the strike dimensions E-1 Place inside mounting plate flush against the door shown. 3 ⁄ " (L) X 1" (D) X 1" (W) as shown.
Page 6
Kaba Access Control warrants this product to be free from defects in material and workmanship under normal use and service for a period of three (3) years. Kaba Access Control will repair or replace, at our discretion, 5000 Series Locks found by Kaba Access Control analysis to be defective during this period.
KIL cylinder. handing as shown. You must use a Kaba tailpiece. The K 2 tailpiece is preassembled with H-2 Insert one of the supplied keys (a) into the out- the Kaba 1599.
I-2 Insert the outside lever (a) until it is flush to the I-10 Insert the lever release tool (d) into the small hole (f) under lever as outside unit assembly (b). To secure the outside shown. Gently push lever catch up until it clicks. Remove tool, then lever, insert the release tool (d) (or screwdriver) into remove outside lever (a).
For example, if your new code is 1,2,,7,2,4,6,8, the correct buttons to press in K. TESTING THE OPERATION OF THE LOCK the exact order are: K-1 Rotate inside lever and hold. Ensure that the mortise latch is fully retract- #1,2,3,4,5,6,7,8,#,0,0,0,#,1,3,5,7,2,4,6,8,#,#. To determine if you have successful- ed and flush with the mortise faceplate.