H System Options - Paradyne Hotwire 8774 User Manual

System Options
Î
Î
8774-A2-GB20-10
For System Options, refer to Table A-4. To access the System Options screen,
follow this menu selection sequence:
Main Menu Configuration
main/config/system
Slot 4
DSL Mode:
Test Timeout:
Test Duration (min):
Telco Initiated Loopbacks:
Remote Telco Line Loopback:
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu
Save
Table A-4. System Options (1 of 2)
DSL Mode
Possible Settings: LTU, NTU
Default Setting: LTU
Controls whether the unit is configured as a control unit or tributary unit.
LTU – The unit is configured as a control unit (Line Termination Unit).
NTU – The unit is configured as a tributary unit (Network Termination Unit). This unit will
request its IP address from the LTU during establishment of the PPP link.
NOTE: Changing this option will reset the card.
Test Timeout
Possible Settings: Enable, Disable
Default Setting: Enable
Allows tests to end automatically. The feature should be enabled when the unit is
remotely managed, so that control can be regained after a test is accidentally executed.
Enable – Loopback and pattern tests end when test duration is reached.
Disable – Tests run until manually terminated from the Network Tests screen or
remotely (network initiated tests). Refer to
Test Duration (min)
Possible Settings: 1–120
Default Setting: 10
Number of minutes for a test to be active before automatically ending.
H
Test Duration (min) option appears when Test Timeout is enabled.
1 to 120 – Amount of time in minutes for a test to run before terminating.
December 1998
Configuration Option Tables
Load Configuration From
SYSTEM OPTIONS
LTU
Enable
10
Enable
Disabled
Running Network Tests
System
Hotwire
Model: 8774
Î Î
Î Î
MainMenu Exit
in Chapter 5, Testing .
A-7