Using The Asynchronous Terminal Interface; H User Interface Access; H Management Serial Port Settings - Paradyne Hotwire 8774 User Manual

Using the Asynchronous Terminal
Interface
User Interface Access
Management Serial Port Settings
8774-A2-GB20-10
You can communicate with the asynchronous terminal interface (ATI) using one
of the following methods:
H
Direct connection through the Management Serial port of the DSLAM (locally
or via an external modem).
H
Telnet session using a Network Management System (NMS) connected to a
LAN/WAN port on the DSLAM.
H
Telnet session through the Embedded Operations Channel (EOC).
NOTE:
Only one asynchronous terminal interface session can be active at a time,
and another user's session cannot be forced to end. To automatically log out
a user due to inactivity, enable the Inactivity Timeout option (see Table A-5,
Telnet Session Options, in Appendix A, Configuration Option Tables ).
Security can limit ATI access several ways. To set up security or a login ID, refer
to Chapter 7, Security .
Ensure that the device you connect communicates using these settings:
H
Data rate set to 9.6 kbps.
H
Character length set to 8.
H
Parity set to None.
H
Stop Bits set to 1.
Refer to the Installation Guide for your DSLAM.
December 1998
2
2-1