Ip Addressing; H Selecting An Ip Addressing Scheme - Paradyne Hotwire 8774 User Manual

IP Addressing

Selecting an IP Addressing Scheme
8774-A2-GB20-10
The NTU's network interface IP address is assigned through the peer IP address
of the LTU's Network Interface menu. The NTU obtains the LTU's IP address and
subnet mask when the PPP link is established over the EOC. The LTU IP
address and subnet mask are configured from the Communication Protocol
Options menu.
The 8774 Termination Unit is assigned an IP address and subnet through the
DSLAM DSL Card Configuration menu. Once the address is assigned, you can
use the 8774 Termination Unit's ATI to assign:
H
Peer IP addresses to the four M/SDSL ports. These addresses are used as
the IP addresses of the remote units. See Table A-1,
Options, in Appendix A, Configuration Option Tables .
H
An IP address for each NMS to act as a trap manager. See
Table A-6, SNMP Traps
H
An IP address for the TFTP server you wish to use to upload and download
Configuration Loader
configurations. See
Configuration .
Review the following information in preparation for selecting an IP addressing
scheme.
H
Any legal host address is allowed for a given subnet. The address choice
within the subnet is arbitrary.
H
A single route to a subnet is all that is needed to reach every device on a
subnet. The 8774 Termination Unit's routing table supports a maximum of
20 routes.
December 1998
Options, in Appendix A, Configuration Option Tables .
in Chapter 3, Initial Startup and
8
Network Interface
8-1