Paradyne Hotwire 8774 User Manual page 86

Configuration Option Tables
A-12
Table A-6. SNMP Traps Options (2 of 3)
NMS n IP Address
Possible Settings: 000.000.000.000 – 223.255.255.255, Clear
Default Setting: 000.000.000.000
Specifies the Internet Protocol address used to identify each SNMP trap manager.
000.000.000.000 – 223.255.255.255 – Enter an address for each SNMP trap manager.
The range for the first byte is 000 to 223, with the exception of 127. The range for the
remaining three bytes is 000 to 255.
Clear – Clears the IP address and sets to all zeros.
NMS n Destination (NTU Only)
Possible Settings: IMC, DSL1, DSL2, DSL3, DSL4
Default Setting: IMC
Provides the network destination path of each trap manager.
IMC – The Internal Management Channel (IMC) is the default network destination. This
is the management interface to the MCC card in the DSLAM.
DSL1 to DSL4 – The specified port is the network destination.
General Traps
Possible Settings: Disable, Warm, AuthFail, Both
Default Setting: Both
Determines which SNMP traps are sent to each trap manager.
Disable – No general trap messages are sent.
Warm – Sends trap message for warmStart events.
AuthFail – Sends trap message for authenticationFailure events.
Both – Sends both trap messages.
NOTE: Refer to Appendix B,
Enterprise Specific Traps
Possible Settings: Enable, Disable
Default Setting: Disable
Determines if SNMP traps are generated for enterprise-specific events.
Enable – SNMP traps are generated for enterpriseSpecific events.
NOTE: Refer to Enterprise Specific Traps
for SNMP Traps .
Disable – No enterprise-specific event traps are sent.
December 1998
Standards Compliance for SNMP Traps
in Appendix B, Standards Compliance
.
8774-A2-GB20-10