Testing
Repeater Loopback
"
5-4
Repeater Loopback (RLB) loops the signal being sent from the DSX-1 port back
to the DSX-1 port and to the network interface.
CAP
CAP
DSL
Port
Transceiver
Framer
Procedure
To run a Repeater Loopback:
1. Position the cursor at the Start command next to Repeater Loopback on the
Network Tests screen.
2. Press Enter.
The Start command is changed to Stop.
3. To manually stop the test, verify that the cursor is positioned at the Stop
command.
4. Press Enter.
A Repeater Loopback cannot be started when any other loopback test is in
progress.
NOTE:
Activating the Repeater Loopback test causes the EOC to be lost to the
remote unit.
December 1998
T1
DSX-1
LIU
Port
Framer
98-16111
8774-A2-GB20-10