IEM Mobil-O-Graph PWA Operating Manual page 119
Long-term blood pressure measuring device
Hide thumbs
Also See for Mobil-O-Graph PWA:
- Operating manual (322 pages) ,
- Operating instructions manual (92 pages) ,
- Instructions for use manual (462 pages)
Table of Contents
Advertisement
Available languages
Available languages
▪
Align the cuff so that no part of the cuff tube can be kinked. Align the cuff so that the lower edge of the cuff
is about 2 cm (0,8 Inch) above your elbow, see Fig. 2.
▪
Place the cuff around the upper arm in such a way that one finger can be inserted underneath the cuff.
▪
Make sure that the artery symbol on the cuff is positioned on the arm artery (brachial artery), see Fig. 2.
▪
When the cuff is put on correctly, the metal strap lies on the outside
of the upper arm (on the elbow side). Here, the fabric strap must
cover the skin underneath the metal strap.
▪
We recommend placing the cuff on the bare upper arm. However,
the cuff can also be worn over a thin shirt or a blouse.
▪
Put the holster on. By varying the length of the strap, you can use
it either as a waist strap or as a shoulder strap.
▪
Insert the Mobil-O-Graph
connection and the buttons are freely accessible for operation.
▪
Switch the Mobil-O-Graph
▪
Start a new blood pressure measurement by pressing the START
button.
®
into the holster so that the cuff
®
on using the ON/OFF button.
Appendix
Fig. 2: Positioning of the cuffs
EN
117
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Mobil-O-Graph PWA and is the answer not in the manual?
Questions and answers
Que veux dire code 6 et code 2
Code 6 means that there are no unsent blood pressure values in the measurement memory of the Mobil-O-Graph®.
Code 2 indicates that the Bluetooth interface of the Mobil-O-Graph® could not be configured properly, possibly due to a communication problem between the device and the Bluetooth module.
This answer is automatically generated
Calibración