Diagnosis & Troubleshooting; Diagnostic Codes - Maytag MAT14CS Service Manual

DiaGNOSiS & TrOuBLeSHOOTiNG
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
If the set-up mode is entered and one of the following has occurred,
the appropriate diagnostic code will be in the display.
Code
d1
Water level detection error on control board or due to power line interference
(cycles and customer display disabled until diagnostic code is manually
cleared).
d3
Water temperature sense error when equipped with temperature sensing
water valve (cycles will fill with unregulated default water temperatures while
the error persists).
d4
Washer lid sense error on control board or due to power line interference
(cycles and customer display disabled until diagnostic code is manually
cleared).
d5
Blocked coin 1 or coin drop control circuit failure (coin recognition and
price display disabled while blockage persists).
d7
Last fill was slow.
d8
Last drain occurring during final spin was slow.
d9
Voltage detected below 90 VAC for 8 seconds.
d12
Motor sense error detected on control board or due to power line
interference.
d13
Blocked coin 2 or coin drop control circuit failure (coin recognition and
price display disabled while blockage persists).
d16
Not receiving communications from installed debit card reader in
Enhanced (Generation 2) Debit mode.

DiaGNOSTiC CODeS

Explanation
6-1