aDDiTiONaL COMPONeNT aCCeSS
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Open the control panel and remove the wire
connector to the coin drop from the control
board (See page 4-13, step 4).
2.
Remove the service access door on top of
the metercase.
Service access
door
reMOve THe COiN DrOP
4-40
3.
Using a 1/4 inch socket unscrew the two
security bolts at the top and bottom of the
metercase.
Security bolts
4.
Pull the coin drop out of the metercase.
Optical sensor
5.
The optical sensor is attached to the back of
the coin drop and can be ordered separately
if needed.