reMOve THe reLaYS
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Remove the control panel (see page 4-1).
2.
Remove the escutcheon (see page 4-7).
3.
Remove one - 1/4 inch hex head screw from
the front of the control panel.
4.
Remove the reversing relay from the back
side.
5.
The motor main winding relay is also held in
place by the same screw as the first relay.
1.
2.
3.
1/4 inch hex
head screw
4.
4-8
reMOve GrOuND Wire
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Remove the control panel (see page 4-1).
Remove the escutcheon (see page 4-7).
Remove one - 1/4 inch hex head screw from
the front of the control panel.
Remove the wire from the opposite side.
Ground wire