Component Testing Information - Maytag SAV2555AW Series Technical Information

Component Testing Information

To avoid risk of electrical shock, personal injury, or death, disconnect power to washer before servicing, unless
testing requires it.
Illustration
2 Speed Motor
CCW rotation from
viewed from shaft
end.
1/2HP
120V/60hz, 8.7 amps
@ 1725 RPM/7.4
amps @ 1140 RPM
Main wattage,
700/570 watts
Water valve
120V 50/60hz, 5
watts Cold Side 2.25
gpm, Hot Side 2.00
gpm, Mix 3.00 gpm at
30-120 psi
Drain Pump
Lid Switch
Timer
Pressure Switch
October 2003
!
Component
See section "Internal Motor Diagram and Schematic for wiring
contacts.
Measure resistance of terminals on each valve.
Resistance across each valve.
Verify Drain Pump is not clogged or damaged.
Disconnect wire terminals from switch. Test terminals with
switch closed. Test terminals with switch open.
Verify input and output voltage is present
Do not disconnect the pressure hose from pressure switch to
perform measurements. Measure resistance across the
following terminals.
Terminal 1 to 2
Terminal 1 to 3
WARNING
Test Procedure
4
1000 Ω ± 10%
Continuity >1Ω
Infinite
. Refer to timing
sequence chart.
Refer to wiring
diagram/schemat
ic for correct
contacts.
Continuity >1Ω
Infinite
16022733 Rev. 0
Results
Ω
1M
Ω
1M