How To Operate Numeric Lcp (Nlcp) - Danfoss VLT HVAC Drive Instruction Manual

VLT ® HVAC Drive Instruction Manual
The parameter shortcut
The parameter shortcut allows direct access to any parameter.

5.1.3. How to operate numeric LCP (NLCP)

The following instructions are valid for the
NLCP (LCP 101).
The control panel is divided into four function-
al groups:
1.
2.
3.
4.
Select one of the following modes:
Status Mode:
justable frequency drive or the motor.
If an alarm occurs, the NLCP automatically
switches to status mode.
A number of alarms can be displayed.
Quick Set-up or Main Menu Mode:
parameters and parameter settings.
LEDs:
•
•
•
Main Menu
The parameters can be accessed immediately unless a password has been created via par. 0-60,
0-61, 0-65 or 0-66.
Quick Set-up
parameters.
The parameter values can be changed using the up/down arrows when the value is flashing.
Select the main menu by pressing the [Menu] key a number of times until the main menu LED is
lit.
can be carried out by holding down the [Main Menu] key for 3 seconds.
Numeric display.
Menu key and LEDs - changing pa-
rameters and switching between dis-
play functions.
Navigation keys and LEDs.
Operation keys and LEDs.
NOTE
Parameter copy is not possible
with the Numeric Local Control
Panel (LCP101).
Displays the status of the ad-
Green LED/On: Indicates if control
section is on.
Yellow LED/Wrn.: Indicates a warn-
ing.
Flashing red LED/Alarm: Indicates
an alarm.
is used for programming all parameters.
is used to set up the adjustable frequency drive using only the most essential
MG.11.A4.22 - VLT ® is a registered Danfoss trademark
5. How to operate the adjustable frequency
Illustration 5.1: Numerical LCP (NLCP)
Illustration 5.2: Status display example
Display
Illustration 5.3: Alarm display example
Menu key
[Menu] Select one of the following modes:
• Status
• Quick Set-up
• Main Menu
drive
5
55