Danfoss VLT HVAC Drive Instruction Manual page 31

VLT ® HVAC Drive Instruction Manual
4.1.5. Line connection for A2 and A3
Illustration 4.2: First mount the two screws on the mounting plate, slide it into place and tighten fully.
Illustration 4.3: When mounting cables, first mount and tighten the ground cable.
The ground connection cable cross-section must be at least 0.016 in
2 rated line power wires terminated separately according to
61800-5-1
.
MG.11.A4.22 - VLT ® is a registered Danfoss trademark
4. Electrical installation
2 2
[10 mm ] or
EN 50178/IEC
31
4