Data Readouts 2 - Danfoss VLT HVAC Drive Instruction Manual

VLT ® HVAC Drive Instruction Manual
6.1.5. Parameter Selection
In main menu mode, the parameters are divi-
ded into groups. Select a parameter group
using the navigation keys.
The following parameter groups are accessi-
ble:
After selecting a parameter group, choose a
parameter using the navigation keys.
The middle section on the GLCP display shows
the parameter number and name, as well as
the selected parameter value.
6.1.6. Changing Data
1.
2.
3.
4.
5.
6.
Press the [Quick Menu] or [Main Menu] key.
Use the [ ] and [ ] keys to find the parameter group to edit.
▲ ▼
Use the [ ] and [ ] keys to find the parameter to edit.
▲ ▼
Press the [OK] key.
Use the [ ] and [ ] keys to select the correct parameter setting. Or, to move to digits
▲ ▼
within a number, use the keys. The cursor indicates the selected digit to be changed.
The [ ] key increases the value, the [ ] key decreases the value.
▲
Press the [Cancel] key to disregard the change, or press the [OK] key to accept the
change and enter the new setting.
MG.11.A4.22 - VLT ® is a registered Danfoss trademark
6. How to program the adjustable frequency
Group no. Parameter group:
0 Operation/Display
1 Load/Motor
2 Brakes
3 References/Ramps
4 Limits/Warnings
5 Digital In/Out
6 Analog In/Out
8 Comm. and Options
9 Profibus
10 CAN ser. com. bus
11 LonWorks
13 Smart Logic
14 Special Functions
15 Drive Information
16 Data Readouts
18

Data Readouts 2

20 Drive Closed-loop
21 Ext. Closed-loop
22 Application Functions
23 Time-based Functions
25 Cascade Controller
26 Analog I/O Option MCB 109
Table 6.4: Parameter groups.
Illustration 6.10: Display example.
▼
drive
6
97