Danfoss VLT HVAC Drive Instruction Manual page 75

VLT ® HVAC Drive Instruction Manual
0-70
Value:
2000-01-01 00:00 –
2099-12-01 23:59
Function:
Sets the date and time of the internal clock.
The format to be used is set in par. 0-71 and
0-72.
0-71
Value:
YYYY-MM-DD
DD-MM-YYYY
MM/DD/YYYY
Function:
Sets the date format to be used in the LCP.
0-72
Value:
24 H
12 H
Function:
Sets the time format to be used in the LCP.
0-74
Value:
OFF
to move the cursor. A character can be changed when it is high-
lighted by a cursor. A character can be inserted by placing the
cursor between two characters and pressing ▲ or ▼.
Set Date and Time
2000-01-01
00:00
NOTE
This parameter does not display
the actual time. This can be read
in par. 0-89. The clock will not
begin counting until a setting
different from default has been
made.
Date Format
Time Format
DST/Summertime
MG.11.A4.22 - VLT ® is a registered Danfoss trademark
6. How to program the adjustable frequency
Manual
Function:
Choose how Daylight Saving Time/Summer-
time should be handled. For manual DST/
Summertime, enter the start date and end
date in par. 0-76 and 0-77.
0-76 DST/Summertime Start
Value:
2000-01-01 00:00 –
2099-12-31 23:59
Function:
Sets the date and time when Summertime/
DST starts. The date is programmed in the
format selected in par. 0-71.
0-77 DST/Summertime End
[0]
Value:
[1]
2000-01-01 00:00 –
[2]
2099-12-31 23:59
Function:
Sets the date and time when Summertime/
DST ends. The date is programmed in the for-
mat selected in par. 0-71.
[*0]
1-00 Configuration Mode
[1]
Value:
Open-loop
Closed-loop
Function:
Open-loop
[0]: Motor speed is determined by
applying a speed reference, or by setting de-
sired speed when in Hand Mode.
Open-loop is also used if the adjustable fre-
[0]
quency drive is part of a closed-loop control
drive
[2]
6
2000-01-01
00:00
2000-01-01
00:00
[0]
[3]
75