Danfoss VLT HVAC Drive Instruction Manual page 65

VLT ® HVAC Drive Instruction Manual
Illustration 6.1: Quick menu view.
*The display showing depends on choices made in parameter 0-02 and 0-03. The default setting
of parameters 0-02 and 0-03 depends on which region of the world the adjustable frequency drive
is supplied to, but it can be re-programmed as required.
No Operation
If
enable start.
Coast Inverse
If
essary to enable start.
Select
•
•
Select
graphs.
Only display parameters selected in par. 0-20 and par. 0-24 can be viewed. It is possible to store
up to 120 samples in the memory for later reference.
0-01
Value:
English UK (English)
1-20
Value:
0.09 - 500 kW
is selected in terminal 27, no connection to +24 V on terminal 27 is necessary to
(factory default value) is selected in Terminal 27, a connection to +24V is nec-
Changes made
to get information about:
the last 10 changes. Use the up/down navigation keys to scroll between the last 10
changed parameters.
the changes made since default setting.
Loggings
to get information about the display line readouts. The information is shown in
Language
Motor power parameter
Size related
MG.11.A4.22 - VLT ® is a registered Danfoss trademark
6. How to program the adjustable frequency
Par. Designation
0-01 Language
1-20 Motor Power
1-21 Motor Power*
1-22 Motor Voltage
1-23 Motor Frequency
1-24 Motor Current
1-25 Motor Nominal Speed
3-41 Ramp 1 Ramp-up Time
3-42 Ramp 1 Ramp-down Time [s]
4-11 Motor Speed Low Limit
4-12 Motor Speed Low Limit*
4-13 Motor Speed High Limit
4-14 Motor Speed High Limit*
3-11 Jog Speed*
5-12 Terminal 27 Digital Input
5-40 Function Relay
Table 6.3: Quick Set-up parameters
Function:
Enter the nominal motor power (in kW) ac-
cording to the motor nameplate data. The
[0]
default value corresponds to the nominal rat-
ed output of the unit.
This parameter cannot be adjusted while the
motor is running.
drive
[Units]
[kW]
[HP]
[V]
[Hz]
[A]
[RPM]
[s]
[RPM]
[Hz]
[RPM]
[Hz]
[Hz]
6
65