How To Program The Adjustable Frequency Drive; How To Program - Danfoss VLT HVAC Drive Instruction Manual

VLT ® HVAC Drive Instruction Manual

6. How to program the adjustable frequency drive

6.1. How to program

6.1.1. Parameter Set-up
Group Title
0-
1-
2-
3-
4-
5-
6-
8-
9-
10-
11-
13-
14-
15-
16-
18-
20-
21-
22-
23-
Table 6.1: Parameter Groups
Operation and Display
Load / Motor
Brakes
Reference / Ramps
Limits / Warnings
Digital in/out
Analog in/out
Communication and options
Profibus
CAN ser. com. bus
LonWorks
Smart logic
Special functions
FC information
Data readouts
Data readouts 2
FC closed-loop
Extended closed loop
Application functions
Timed actions
MG.11.A4.22 - VLT ® is a registered Danfoss trademark
6. How to program the adjustable frequency
Function
Parameters related to the fundamental functions of
the adjustable frequency drive, function of the LCP
buttons and configuration of the LCP display.
Parameter group for motor settings.
Parameter group for setting brake features in the ad-
justable frequency drive.
Parameters for reference handling, definitions of lim-
itations and configuration of the reaction of the fre-
quency converter to changes.
Parameter group for configuring limits and warnings.
Parameter group for configuring the digital inputs and
outputs.
Parameter group for configuring the analog inputs
and outputs.
Parameter group for configuring communications and
options.
Parameter group for Profibus-specific parameters.
Parameters for the configuration of the CAN serial
communication bus, which is the underlying bus sys-
tem for DeviceNet option.
Parameter group for LonWorks parameters
Parameter group for Smart Logic Control
Parameter group for configuring special adjustable
frequency drive functions.
Parameter group containing adjustable frequency
drive information such as operating data, hardware
configuration and software versions.
Parameter group for data read-outs, such as current
references, voltages, control, alarm, warning and sta-
tus words.
This parameter group contains the last 10 Preventive
Maintenance logs.
This parameter group is used for configuring the
closed-loop PID controller that controls the output
frequency of the unit.
Parameters for configuring the three extended closed-
loop PID controllers.
These parameters monitor HVAC applications.
These parameters are for actions to be performed on
a daily or weekly basis, such as different references
for working hours/non-working hours.
drive
6
63