Danfoss VLT HVAC Drive Instruction Manual page 37

VLT ® HVAC Drive Instruction Manual 4. Electrical installation
4.1.11. Motor connection for A2 and A3
Follow these drawings step-by-step for connecting the motor to the adjustable frequency drive.
4
Illustration 4.11: First terminate the motor ground, then place motor U, V and W wires in the plug and tighten
them.
Illustration 4.12: Mount cable clamp to ensure 360 degree connection between chassis and shield; ensure
that the outer insulation of the motor cable is removed under the clamp.
37
MG.11.A4.22 - VLT ® is a registered Danfoss trademark