How To Operate Numeric Lcp (Nlcp) - Danfoss VLT HVAC Drive FC 102 Programming Manual

How to Programme
NOTICE
An active HAND-OFF-AUTO signal via the digital inputs
2 2
has higher priority than the control keys [Hand On] –
[Auto On].
[Reset]
Press [Reset] to reset the frequency converter after an
alarm (trip). It can be selected as [1] Enable or [0] Disable
via parameter 0-43 [Reset] Key on LCP.
The parameter shortcut can be carried out by pressing the
[Main Menu] key for 3 s. The parameter shortcut allows
direct access to any parameter.

2.1.2 How to Operate Numeric LCP (NLCP)

The control panel is divided into 4 functional groups:
1. Numeric display.
2. Menu key and indicator lights (LEDs) - changing
parameters and switching between display
functions.
3. Navigation keys and indicator lights (LEDs).
4. Operation keys and indicator lights (LEDs).
NOTICE
Parameter copy is not possible with NLCP (LCP101).
Select 1 of the following modes:
Status mode: Displays the status of the frequency
converter or the motor.
If an alarm occurs, the NLCP automatically switches to
Status mode.
A number of alarms can be displayed.
Quick Set-up or Main Menu mode: Display parameters
and parameter settings.
14
®
VLT HVAC Drive FC 102
1
2
3
4
Illustration 2.13 Numerical LCP (NLCP)
Illustration 2.14 Status Display Example
Indicator lights (LEDs):
•
•
•
Illustration 2.15 Alarm Display Example
Danfoss A/S © 03/2015 All rights reserved.
Status Quick
Setup
Menu
OK
On
Warn.
Alarm
Hand Auto
O
on on
22.8
Green LED/On: Indicates if control section is on.
Yellow LED/Warn.: Indicates a warning.
Flashing red LED/Alarm: Indicates an alarm.
A 17
Setup
Main
Menu
Reset
rpm
Setup 1
Setup 1
MG11CE02