H3C MSR 2600 Configuration Manual page 145

0
NAT outbound information:
There are 1 NAT outbound rules.
Interface: GigabitEthernet1/2
ACL: 2000
NO-PAT: N
NAT logging:
Log enable : Disabled
Flow-begin : Disabled
Flow-end : Disabled
Flow-active: Disabled
NAT mapping behavior:
Mapping mode: Address and Port-Dependent
ACL : ---
NAT ALG:
DNS: Enabled
FTP: Enabled
H323: Enabled
ICMP-ERROR: Enabled
# Use the display nat session verbose command to display NAT session information generated when
Host A accesses the WWW server.
[Router] display nat session verbose
Initiator:
Source IP/port: 192.168.1.10/52992
Destination IP/port: 200.1.1.10/2048
VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: ICMP(1)
Responder:
Source IP/port: 200.1.1.10/4
Destination IP/port: 202.38.1.3/0
VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: ICMP(1)
State: ICMP_REPLY
Application: INVALID
Start time: 2012-08-15 14:53:29
Interface(in) : GigabitEthernet1/1
Interface(out): GigabitEthernet1/2
Initiator->Responder:
Responder->Initiator:
Total sessions found: 1
202.38.1.2
Address group: 0
Reversible: N
TTL: 12s
1 packets
1 packets
130
202.38.1.3
Port-preserved: N
84 bytes
84 bytes