H3C MSR 2600 Configuration Manual page 150

Interface: GigabitEthernet1/2
Protocol: 6(TCP)
Global IP/port: 202.38.1.1/25
Local IP/port: 10.110.10.4/25
Interface: GigabitEthernet1/2
Protocol: 6(TCP)
Global IP/port: 202.38.1.1/80
Local IP/port: 10.110.10.1/80
Interface: GigabitEthernet1/2
Protocol: 6(TCP)
Global IP/port: 202.38.1.1/8080
Local IP/port: 10.110.10.2/80
NAT logging:
Log enable : Disabled
Flow-begin : Disabled
Flow-end : Disabled
Flow-active: Disabled
NAT mapping behavior:
Mapping mode: Address and Port-Dependent
ACL : ---
NAT ALG:
DNS: Enabled
FTP: Enabled
H323: Enabled
ICMP-ERROR: Enabled
# Use the display nat session verbose command to display NAT session information generated when
Host accesses the FTP server.
[Router] display nat session verbose
Initiator:
Source IP/port: 202.38.1.10/1694
Destination IP/port: 202.38.1.1/21
VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: TCP(6)
Responder:
Source IP/port: 10.110.10.3/21
Destination IP/port: 202.38.1.10/1694
VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: TCP(6)
State: TCP_ESTABLISHED
Application: FTP
Start time: 2012-08-15 14:53:29
Interface(in) : GigabitEthernet1/2
TTL: 3597s
135