H3C MSR 2600 Configuration Manual page 64

0030-3030-662e-6532-3030-2e30-3030-322d-4574-6865-726e-6574-302f-30.
The MAC address of the interface Ethernet 1/1 on Router C is 000f-e200-01c0.
Figure 16 Network diagram
Configuration procedure
1. Specify an IP address for Ethernet 1/1 on Router A:
<RouterA> system-view
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] ip address 10.1.1.1 25
[RouterA-Ethernet1/1] quit
2. Configure the DHCP server:
# Enable DHCP.
[RouterA] dhcp enable
# Enable the DHCP server on Ethernet 1/1.
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] dhcp select server
[RouterA-Ethernet1/1] quit
# Create DHCP address pool 0.
[RouterA] dhcp server ip-pool 0
# Configure a static binding for Router B.
[RouterA-dhcp-pool-0] static-bind ip-address 10.1.1.5 25 client-identifier
0030-3030-662e-6532-3030-2e30-3030-322d-4574-6865-726e-6574-302f-30
# Configure a static binding for Router C.
[RouterA-dhcp-pool-0] static-bind ip-address 10.1.1.6 25 hardware-address
000f-e200-01c0
# Specify the DNS server and gateway.
[RouterA-dhcp-pool-0] dns-list 10.1.1.2
[RouterA-dhcp-pool-0] gateway-list 10.1.1.126
Verifying the configuration
After the preceding configuration is complete, Router B can obtain IP address 10.1.1.5 and other network
parameters, and Router C can obtain IP address 10.1.1.6 and other network parameters from Router A.
You can use the display dhcp server ip-in-use command on the DHCP server to view the IP addresses
assigned to the clients.
49