Configuration Procedure; Verifying The Configuration - H3C MSR 2600 Configuration Manual

Figure 75 Network diagram
Host

Configuration procedure

1. Configure Router A:
# Configure a global unicast address for interface Ethernet 1/1.
<RouterA> system-view
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] ipv6 address 3001::1/64
[RouterA-Ethernet1/1] quit
# Configure a global unicast address for interface Ethernet 1/2 and enable it to advertise RA
messages (an interface does not advertises RA messages by default).
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] ipv6 address 2001::1/64
[RouterA-Ethernet1/2] undo ipv6 nd ra halt
[RouterA-Ethernet1/2] quit
2. Configure Router B:
# Configure a global unicast address for interface Ethernet 1/1.
<RouterB> system-view
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] ipv6 address 3001::2/64
[RouterB-Ethernet1/1] quit
# Configure an IPv6 static route to the host.
[RouterB] ipv6 route-static 2001:: 64 3001::1
3. Configure the host:
Enable IPv6 on the host to automatically obtain an IPv6 address through IPv6 ND.
# Display neighbor information for Ethernet 1/2 on Router A.
[RouterA] display ipv6 neighbors interface ethernet 1/2
IPv6 Address
FE80::215:E9FF:FEA6:7D14
2001::15B:E0EA:3524:E791
The output shows that the IPv6 global unicast address that the host obtained is
2001::15B:E0EA:3524:E791.

Verifying the configuration

# Display IPv6 interface information on Router A.
[RouterA] display ipv6 interface ethernet 1/1
Ethernet1/1 current state: UP
Line protocol current state: UP
Router A
Eth1/2
Eth1/1
2001::1/64
3001::1/64
Type: S-Static
Router B
Eth1/1
3001::2/64
D-Dynamic
Link Layer VID
0015-e9a6-7d14 N/A
0015-e9a6-7d14 N/A
199
I-Invalid
Interface State T Age
Eth1/2 STALE D 1238
Eth1/2 STALE D 1248