H3C MSR 2600 Configuration Manual page 283

# Create an IPv6 tunnel interface tunnel 1.
[RouterA] interface tunnel 1 mode ipv6
# Specify an IPv6 address for the tunnel interface.
[RouterA-Tunnel1] ipv6 address 3001::1:1 64
# Specify the IP address of Serial 2/0 as the source address for the tunnel interface.
[RouterA-Tunnel1] source 2001::11:1
# Specify the IP address of Serial 2/1 on Router B as the destination address for the tunnel
interface.
[RouterA-Tunnel1] destination 2002::22:1
[RouterA-Tunnel1] quit
# Configure a static route destined for the IPv6 network group 2 through the tunnel interface.
[RouterA] ipv6 route-static 2002:3:: 64 tunnel 1
Configure Router B:
•
# Specify an IPv6 address for Ethernet 1/1.
<RouterB> system-view
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] ipv6 address 2002:3::1 64
[RouterB-Ethernet1/1] quit
# Specify an IPv6 address for Serial 2/1, which is the physical interface of the tunnel.
[RouterB] interface serial 2/1
[RouterB-Serial2/1] ipv6 address 2002::22:1 64
[RouterB-Serial2/1] quit
# Create an IPv6 tunnel interface tunnel 2.
[RouterB] interface tunnel 2 mode ipv6
# Specify an IPv6 address for the tunnel interface.
[RouterB-Tunnel2] ipv6 address 3001::1:2 64
# Specify the IP address of Serial 2/1 as the source address for the tunnel interface.
[RouterB-Tunnel2] source 2002::22:1
# Specify the IP address of Serial 2/0 on Router A as the destination address for the tunnel
interface.
[RouterB-Tunnel2] destination 2001::11:1
[RouterB-Tunnel2] quit
# Configure a static route destined for the IPv6 network group 1 through the tunnel interface.
[RouterB] ipv6 route-static 2002:1:: 64 tunnel 2
Verifying the configuration
# Use the display ipv6 interface command to display the status of the tunnel interfaces on Router A and
Router B. The output shows that the tunnel interfaces are up. (Details not shown.)
# Ping the IPv6 address of the peer interface Ethernet 1/1 from each router. The following shows the
output on Router A.
[RouterA] ping ipv6 -a 2002:1::1 2002:3::1
Ping6(56 data bytes) 2002:1::1 --> 2002:3::1, press escape sequence to break
56 bytes from 2002:3::1, icmp_seq=0 hlim=64 time=0.000 ms
56 bytes from 2002:3::1, icmp_seq=1 hlim=64 time=0.000 ms
56 bytes from 2002:3::1, icmp_seq=2 hlim=64 time=0.000 ms
56 bytes from 2002:3::1, icmp_seq=3 hlim=64 time=0.000 ms
268