Front Glass Positioning - Hussmann Elite Series Installation & Operation Manual

1-4 I
nstallatIon
Leveler Adjustment
Position the first case at the highest
point . Set a long level (4 ft [1220 mm] or
more) on the upper front panel of the
case . Use an open-end wrench to turn leg
levelers until the case is level from end to
end and from front to back . Check all 6
legs on 8 ft (2438 mm) cases, or 8 legs on
12 ft (3658 mm) cases .
Note: To avoid removing concrete floor-
ing, begin lineup leveling from the highest
point of the store floor .
Attention to glass position is critical during
the leveling process.
Adjusting leg levelers will affect the posi-
tion of the glass . Make certain that the
glass is square with the case, and does not
interfere with other glass or case ends .
If the glass is still out of alignment, refer
to the following Front Glass Positioning
instructions .
To prevent injury from falling
glass during adjustment, one
person must support glass
while a second person makes
adjustments.
P/N 0453549_M
U
Leg Leveler

FRONT GLASS POSITIONING

Do not adjust glass until case is level.
In many instances, proper leveling will align
glass without further adjustment.
Glass
Movement
Leg
Leveler
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
Level on
Upper Front
Panel
Adjustable
Raise
Turn Leg Leveler clock-wise to raise case
M
INIMUM
H
EIGHT
M
AXIMUM
H
EIGHT
Lower
Glass
Base S
Bracke
Set
Screw
Adjustable
Leg Levele
Raise