Table of Contents
Advertisement
Hussmann® Impact™ Hot Food Merchandiser
Attention to glass position is critical during the leveling process.
Adjusting leg levelers will affect the position of the glass. Make certain that the glass is square with the
case, avoiding interference with other glass and case ends.
If the glass is still out of alignment, refer to the following Glass Positioning instructions.
Glass Positioning
Follow the procedures below to improve the opening and closing of the case front glass.
1. Ensure the case has been leveled according to the Case Leveling procedure.
2. Ensure that the glass handle is installed correctly.
Verify the glass is bottomed out the length of the handle. A bowed handle indicates the glass may
not be bottomed out at the center of the handle.
The handle must be removed before it can be repositioned. The handle is held in place with
silicone that must be completely removed from the handle and the glass. Remove the handle by
pulling it away from the glass (do not use tools to pry this loose). A damaged or bent handle must
be replaced. Apply new silicone into the handle and firmly press onto the glass.
3. Ensure that the glass is seated in the clamp hardware correctly.
Verify glass is bottomed out in clamp hardware.
Glass must be properly supported when adjusting.
11
Installation
Advertisement
Table of Contents
