Glass Positioning - Hussmann SMB Installation And Operation Manual

P/N 0420057A

GLASS POSITIONING

Check the following to improve opening or clos-
ing of the case front glass.
1. Has the case been leveled according to
preceding paragraphs?
2. Is the glass handle installed correctly?
Verify the glass is bottomed out the length of the
handle. A bowed handle indicates the glass may
not be bottomed out at the center of the handle.
The handle must be removed before it can be
repositioned. The handle is held in place with
silicone which must be completely removed from
the handle and the glass. Remove the handle by
pulling it away from the glass (do not use tools to
pry this loose). A damaged or bent handle must be
replaced. Apply new silicone into the handle and
firmly press onto the glass.
3. Is the glass seated in the clamp hardware
correctly?
Verify glass is bottomed out in clamp hardware.
If the glass is not bottomed out in the clamp hard-
ware it can be re-positioned as follows:
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)
A. Remove the glass and clamp hardware from
the case by opening the glass and loosening
set screws in hinge, (Metric 3 millimeter set
screws).
B. Slide the glass and clamp hardware to the side
out of the hinges and lay them on an appro-
priate work surface.
Note: adjacent glass must be closed.
C. Loosen the 8 set screws on the underside of
the clamp hardware.
D. Push the clamp hardware onto the glass until
bottomed out.
E. The clamp hardware must overhang the glass
by an equal amount on each side.
F. Tighten set-screws and re-install on case.
Service Merchandisers
1-5