Merchandiser Electrical Data; Electrical Connections; Field Wiring; Identification Of Wiring - Hussmann Elite Series Installation & Operation Manual

2-4 R
efRIgeRatIon

MERCHANDISER ELECTRICAL DATA

Technical data sheets are shipped with this
manual . The data sheets provide merchandiser
electrical data, electrical schematics, parts lists
and performance data . Refer to the technical
data sheets and merchandiser serial plate for
electrical information .

ELECTRICAL CONNECTIONS

All wiring must be in compliance with NEC
and local codes . All electrical connections
including both supply circuits are to be made in
the electrical Handy Box.
ALWAYS CHECK THE SERIAL PLATE FOR
COMPONENT AMPERES
INSTALLER
It is the contractor's responsibility to
install merchandiser(s) in accordance with
all local building and health codes.
Leads for all electrical circuits are identified by a colored plastic band: neutral
wire for each circuit has either White insulation or a White plastic sleeve in
addition to the color band.
P ............ R
ink efRig
L B . R
ighT Lue efRig
D B .. D
aRk Lue efRosT
P ....... c
uRPLe onDensaTe
B ........ f
Rown an
g * ....... g
Reen RounD
ELECTRICIAN NOTE: Use copper conductor wire only.
P/N 0453549_M
/ e
leCtRICal
WIRING COLOR CODE
. T L
heRmosTaT ow
. T n
heRmosTaT oRm
T . T
eRm heRmosTaT
h
eaTeRs
m
oToRs
*e
iTheR coLoReD
MERCHANDISER MUST BE GROUNDED
t
hese aRe maRkeR ColoRs
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM

FIELD WIRING

Field wiring must be sized for component
amperes stamped on the serial plate . Actual
ampere draw may be less than specified . Field
wiring from the refrigeration control panel to
the merchandisers is required for defrost termi-
nation thermostats and for optional refrigera-
tion thermostats .

IDENTIFICATION OF WIRING

Leads for all electrical circuits are identified by
colored plastic bands . These bands correspond
to the color code sticker (shown below) located
inside the merchandiser's wireway cover .
— LOCK OUT / TAG OUT —
To avoid serious injury or death from electri-
cal shock, always disconnect the electrical
power at the main disconnect when servicing
or replacing any electrical component. This
includes, but is not limited to, such items as
doors, lights, fans, heaters, and thermostats.
T . o
emP Range oR
T . T .........L
emP an
m
aRoon
Y
eLLow
R
eD
s o c
LeeVe R
.
wIRes may vaRy
ighTs
..R
ecePTacLes
...D h
efRosT eaTeRs
........D h
efRosT eaTeRs
i
oLoReD nsuLaTion
.
120V
208V