Installing Bumpers - Hussmann Elite Series Installation & Operation Manual

1-10 I
nstallatIon
Seal Merchandisers
1 . Apply butyl tape across the bottom joint .
Be sure to extend the tape up the back
and front of the case .
Butyl Tape
Butyl Tape
2 . Use field-supplied silicone to fill any gaps
between the front support brackets .

INSTALLING BUMPERS

Elite bumpers are shipped as a continuous
roll . Once installed the continuous bumper
helps to disguise the joint locations, giving the
lineup a smoother look .
1 . Unroll the bumper and allow it to rest at
room temperature for 24 hours prior to
installation to minimize bumper shrinkage
after installation .
2 . Slide end caps onto retainer at right and
left ends of lineup . Align with slot in
retainer, then fasten with screws provided .
End Cap
P/N 0453549_M
Screw
Retainer
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
3 . Measure the distance between inside end
1
of caps and add
4 ft (1220 mm) . Adding the additional
material will compensate for stretching
which occurs during installation .
Miter Box
Miter Box
4 .
Cut the bumper to length with a miter saw
for a precise, right-angle cut .
5 . Lubricate the inside of the vinyl with
soapy water or silicone spray .
6 . Starting at the left end of the line up, butt
end of the vinyl bumper against end cap .
While applying pressure, bend back vinyl
top so that vinyl legs are positioned with-
in the base grooves . Roll vinyl bumper
over full length of retainer, then tap with
rubber mallet to ensure vinyl is securely
locked into retainer .
7 . If necessary wipe clean with any house-
hold cleaning product .
/ inch (3 mm) for each
8
Bumper
Bumper