Fluorescent Fixtures; Procedure For Installing Lighted Shelves - Hussmann Elite Series Installation & Operation Manual

P/N 0453549_M

FLUORESCENT FIXTURES

The ballasts used in Excel models have built-
in anti-arc protection . An electrical arc may
occur if a shelf plug is not seated properly, or
if a lamp is not properly seated in a lampholder .
The ballast will shut down when it detects an
arc . Two to four lamps will be out in the mer-
chandiser when this occurs . Carefully check
the plugs to make sure they are fully seated,
and check the lamps to ensure they are firm-
ly seated in the lamp-holders on the affected
shelves . To reset a ballast that has 'tripped' on
anti-arc, turn off the merchandiser light switch
for a minimum of 15 seconds, then turn it on .
Note: The ballasts used in Elite models have
built-in anti-arc protection . An electrical arc
may occur if a shelf plug is not seated proper-
ly, or if a lamp is not properly seated in a
lampholder . The ballast will shut down when
it detects an arc . Two to four lamps will be
out in the merchandiser when this occurs .
Carefully check the plugs to make sure they
are fully seated, and check the lamps to ensure
they are firmly seated in the lamp-holders on
the affected shelves . To reset a ballast that has
'tripped' on anti-arc, turn off the merchandis-
er light switch for a minimum of 15 seconds,
then turn it on .
— LOCK OUT / TAG OUT —
To avoid serious injury or death from electrical
shock, always disconnect the electrical power at
the main disconnect when servicing or replacing
any electrical component. This includes, but is
not limited to, such items as doors, lights, fans,
heaters, and thermostats.
Shelf Light Plug
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
Shelf Light Receptacle
PROCEDURE FOR INSTALLING
LIGHTED SHELVES
Follow these instructions to ensure good
contact between male and female connectors .
1 . Remove produce from shelf and place in
cooler .
s off
hut power to the merchandIser
2 . Turn off Canopy Light Switch . Remove
all packed shelves .
3 . Remove shelf connectors from power
sockets . Always grip shelf connector by
the handle when removing from socket .
p handle
ull down and then out
disengage. Note that latch tongue must
depress to disengage plug .
Fluorescent
Shelf Light
Plug
Latch Tongue
Elite Service Merchandisers
4-5
.
to
Fluorescent
Shelf Light
Receptacle
Shelf Connector Handle
Crossbar