Hussmann Elite Series Installation & Operation Manual page 18

1-14 I
nstallatIon
Case
Wireway
7 . Install the rear door center trim with
3 / -in . bushing by routing wire harness
4
through 3 / -in . bushing and attach with #8
4
truss head screws .
8 . Reposition top over rear door center trim
and attach using #8 truss head screws .
9 . Reposition scale stand and attach using
#8 truss head screws .
10 . Install scale stand upright cover with #8
blunt tip sheet metal screws .
11 . Connect wiring to power in wireway .
12 . Restore power . Check for proper opera-
tion .
Some stores specify an isolated ground for
scale stand convenience outlets . If required,
apply the following:
• Isolated ground sticker to scale stand .
• Isolated ground tag to ground wire in
case wireway .
P/N 0453549_M
Receptacle
Harness
Route Communication
Cable to Junction Box
as shown. Coil excess
cable in Junction Box.
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
Mount Junction Box at this
location when scale stand
is mounted at Center Mullion.
Communication Cable