Table of Contents
Advertisement
S
5-4
ERVICE
FRONT GLASS ADJUSTMENT
The (optional) front glass panel may be
adjusted from side to side by following these
steps:
1. Lift out return air grilles and shelf supports.
2. Loosen but do not remove nuts in retainer.
There are four nuts in each 4 ft section of
glass.
3. Move glass panels horizontally as needed.
4. Tighten nuts enough to hold glass. Do not
over-tighten, which will crack or break glass.
5. Replace shelf supports and return air
grilles.
CAUTION
!
Do not over-tighten nuts. Excess pressure
will cause glass to break.
Glass
(Optional)
Top Rail
Bumper
P/N 0518279_A
REPLACING ELECTRONIC BALLASTS
Rail Lamp Ballast
The rail lamp ballast is located in the wireway,
behind the lower front panel at the left-hand
end of the merchandiser.
NOTE: The rail lamp switch is located on the
rail.
To gain access:
1. D
2. Remove the lower front panel by lifting it
3. Remove screws attaching the wireway cover,
4. Service or replace ballast as required.
5. Reconnect the electrical power.
Product Stop
Return Air Grille
Shelf Support
U.S. & Canada 1-800-922-1919 • Mexico 1-800-522-1900 • www.hussmann.com
ISCONNECT THE ELECTRICAL POWER TO
.
THE MERCHANDISER
up and out.
then remove cover.
Reassemble items as they were originally
installed.
Lower Front
Panel
Ballast located
inside wireway
Advertisement
Table of Contents
