Hussmann Elite Series Installation & Operation Manual page 17

P/N 0453549_M
9 . Replace wireway cover .
10 . Restore power .
Installing Optional Scale Stand
MOA 0458960
1 . Turn off power to case .
2 . Determine location by positioning the
scale stand on the rear of the case between
door frames .
3 . Using holes in scale stand bracket as a
template, mark hole locations on rear and top
of case .
4 . Remove scale stand . Drill
eter pilot holes through metal liners at the
marked locations .
etal liners are less than 1
NOTE: M
--
inch thick do not drill beyond Metal
.
liners
Screw - SM #8-18 x
Truss Head
(3 required)
3/4 Bushing
LH Upright
Wireway
5 . Move top panel away from back of case .
Remove center rear door trim and remove
LH Upright wireway cover to allow routing
of receptacle harness .
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
1 / -inch diam-
8
/ -
8
Insulation in this area to be notched
/
as needed for wire harness routing.
3
8
Connect after routing wiring through case.
Isolated Ground Sticker
(If required)
Convenience Outlet
Harness -
Receptacle
Scale Stand Upright Cover
Screw - SM #8-18 x
(2 required)
Rear Door Center Trim
6 . NOTE:
R
eceptacle haRness wiRing must
have insulation sleeve installed pRioR to
Leaving about 12 inches of harness
.
Routing
hang out of case, route receptacle harness
wiring from the 3
LH upright wireway through hole and into
case wireway .
Install strain relief connector where
Communication Cable exits scale
stand assembly. Use plug button if
Communication Cable is not required.
Communication Cable
Route cable with 12-in.
/ Hex Head outside the strain relief
3
8
connector in the scale stand
NOTE: c
oMMunication cable wiring can
be routed siMilarly
Screw - SM #8-18 x 3/8
Truss Head
Case Wireway
/ -in . bushing, down the
4
.
Elite Service Merchandisers
1-13