Hussmann Elite Series Installation & Operation Manual page 16

1-12 I
nstallatIon
Installing Optional Wrap Board
MOA 0470438
1 . Turn off power to case .
2 . Determine location by positioning the
wrap board on the rear of the case between
door frames .
3 . Align the assembly on the back of the case
as shown below .
4 . Using holes in wrapping board bracket
as a template, mark hole locations on rear of
case .
5 . Remove wireway cover; make sure there are
no wires behind hole locations.
6 . Drill 3 / -inch (0 .1875) diameter holes for
8
three 1 / -20 thread cutting screws through
4
stainless steel and structural members .
7 . Securely fasten brackets to case .
P/N 0453549_M
8 . Adjust wrapping board as needed . The
attach points for hinging brackets on wrap-
ping board is determined by which position
the assembly is to be mounted . Refer to fig-
ures for LH, RH or Center mounting positions .
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
8.969 for 36-in. Board
8.656 for 48-in. Board
REF
0.812
3.25
REF
Bottom View of Wrap Board Panel
Wrap Board Panel
Bracket - Adj
Bracket Spacer
(2 required)
(2 required)
Screw - / -20 x 0.5-in.
1
4
Hex Head Zinc Plate
Mounting Holes
(2 required for each bracket)
Wrapping Board Assembly for Mounting to Left Hand Side of Case
(Facing Front of Case)
Wrap Board Panel
Bracket - Adj
Bracket Spacer
(2 required)
(2 required)
Screw - / -20 x 0.5-in.
1
4
Hex Head Zinc Plate
Mounting Holes
(2 required for each bracket)
Wrapping Board Assembly for Mounting to Right Hand Side of Case
(Facing Front of Case)
Wrap Board Panel
Bracket - Adj
Bracket Spacer
(2 required)
(2 required)
Screw - / -20 x 0.5-in.
1
4
Hex Head Zinc Plate
Mounting Holes
(2 required for each bracket)
Wrapping Board Assembly for Mounting to Center of 12-Ft Case
or Mounting in Positions Other Than Left, Right or Center of Case
(Facing Front of Case)
8.969 for 36-in. Board
8.656 for 48-in. Board
REF
0.812
0.125-in.
Diameter
Drill 6 additional holes 0.5-in. deep
if not already existing in wrapping board.
Screw - #8 x /
1
2
PHIL AB SMS
(3 required for
each bracket)
Screw - / -20 x 0.75-in.
1
4
Flange Thread Cutting
(3 required for each bracket)
Screw - #8 x /
1
2
PHIL AB SMS
(3 required for
each bracket)
Screw - / -20 x 0.75-in.
1
4
Flange Thread Cutting
(3 required for each bracket)
Screw - #8 x /
1
2
PHIL AB SMS
(3 required for
each bracket)
Screw - / -20 x 0.75-in.
1
4
Flange Thread Cutting
(3 required for each bracket)