Cleaning Coils - Hussmann Elite Series Installation & Operation Manual

P/N 0453549_M
STEP 10 – Clean drip pan assembly (gravity
cases).
Work from the rear of the case . Doors may
be lifted out for easier access to the drip tray .
Follow directions on label above the doors as
shown at right .
Separate the drip tube from the lower end of
the connector as shown below .
The drip tray assembly consists of sections .
Plates connect the sections in 6-, 8-, and 12-ft
cases . For better control, begin at the outside
retainers and work toward the middle . Insert
fingers into the retainer and rotate to the side
as shown in detail photos . Support the drip
tray when rotating the last retainer. Once the
last retainer is disengaged, the entire drip tray
assembly will rotate down and forward .
Privot
Screw
Drip Trough
Drip Pan Assembly
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
Connector
Drip Tube Connector
TO REMOVE DOORS
SLIDE DOORS TO RIGHT OF ARROW THEN
LIFT AND PULL BOTTOM TOWARDS YOU

CLEANING COILS

NEVER USE SHARP OBJECTS AROUND
COILS. Use a soft brush or vacuum brush to
clean debris from coils. Do not puncture coils!
Do not bend fins . Contact an authorized
service technician if a coil is punctured,
cracked, or otherwise damaged .
ICE in or on the coil indicates the refrigeration
and defrost cycle is not operating properly .
Contact an authorized service technician to
determine the cause of icing and to make
adjustments as necesssary . To maintain
product integrity, move all product to a cool-
er until the unit has returned to normal
operating temperatures .
Elite Service Merchandisers
5-5
Retainers