Step by Step Operation
89
5.4.4.1
Example Job 4 - Profile Cutting
In this example job, engravers plastic will be set up to engrave a name badge and then the badge will be
cut out. 1/16th inch standard engravers plastic is used. Two different tools will be used - one to engrave,
and one to profile cut the edges.
As with Example Job 2, the Vacuum Chip Removal System is highly recommended for this application
and is shown in this example.
Prepare Artwork in Vision Software
First, we draw a rectangle using the shape tools
Size the rectangle to be 3" X 1". Set the X bounds to .25 and the Y to .25 to position the badge .25
inches away from the edge guides.
© 2018 Vision Engraving & Routing Systems