Part Ii General Information; Unpacking & Inventory - Vision Phoenix 1212 S5 User Manual

2 General Information
2.1 Unpacking & Inventory
The Phoenix 1212 engraving system has been shipped in one carton, unless other accessories have
been ordered with the machine that will not fit in the box. Examine the condition of the box for external
damage. In the event of apparent external damage, notify your shipping carrier upon receipt, and call your
sales representative or Vision immediately.
Note: The shipping container is considered reusable and should be stored for use in the event of service
need or upgrade.
Step1:
Open the foam packed shipping carton. In the top of the carton will be a cardboard box with all of the
machine accessories. The following items should be included:
ü
1 Phoenix 1212 Machine
ü
1 Phoenix 1212 Warranty Card
ü
1 Phoenix 1212 Installation Guide
ü
1 White/Blue or Orange USB security dongle - Contains User Manual and Vision Software
ü
1 Ethernet Network Cable (P/N 20-1074-00)
ü
1 Power Cord
ü
1 0.015 FLX Plastic Cutter
ü
1 Non-Rotating Diamond 120 Degree
ü
1 Quick Lock Vise Large (P/N 200100-00)
ü
1 Spare Motor Belt (P/N 200507-14.75)
ü
1 Allen Wrench Set
ü
1 Cutter Wrench (P/N 200538-00)
ü
1 Technical Support Label
ü
1 Accessory Sheet
Check to see that all of the items are included. Should any of the contents be missing, damaged, or of
the incorrect type, please call your sales representative or Vision immediately.
Step 2:
Prepare a clean, level surface to put the engraving machine on. Carefully lift the machine out of the
carton and place it on the table.
Step 3:
After unpacking the machine, make sure that you SAVE THE CARTON, FOAM PACK and ANY OTHER
BOXES. They can be reused in the event the system must be transported to another location or returned
for service. Improper packaging for shipment can damage the machine and may void the warranty.
© 2018 Vision Engraving & Routing Systems
Introduction 11