Vision Phoenix 1212 S5 User Manual page 13

DEFINITION OF TERMS (see Figures below)
1. Side Panels - The protective covers on the left and right side of the engraver.
2. Table Base Plate - This is the large flat plate upon which everything else is mounted. All mechanical
alignments are referenced to this plate, so the space upon which you place the engraving table must
be a reasonably level surface.
3. Gantry - The gantry or "bridge" is a large, rectangular bar suspended across the width of the table in
the X-axis. The carriage assembly is supported and rides on the gantry in the X-axis.
4. Carriage Cover - The cover protecting the Carriage Assembly.
5. Y-Axis Stepper Motors - These motors drive the Gantry and Carriage in the Y-Axis direction.
6. X-Axis Stepper Motor - This motor drives the Carriage in the X-Axis direction.
7. Y-Axis Leadscrews - These are threaded rods located underneath the Side Covers. Driven by the
stepper motors, the lead screws rotate and causes the Gantry to move along the rails in the Y-Axis
direction.
© 2018 Vision Engraving & Routing Systems
General Information 13