Vision Phoenix 1212 S5 User Manual page 77

Step by Step Operation 77
In order to set the engraver up for burnishing, we will need to perform a "Set Surface" function. From the
home screen on the LCD panel, press on the Jog Icon. Use the arrows to move the spindle over the
material that was placed on the T-Slot table. Lower the burnishing tool with the Z down button until the
tip of the burnishing tool touches the material. Move the Z down approximately 0.03 – 0.05 inches (0.5 –
1.0mm) to preload the EZ Rider spring. Select the set surface button. The Spindle will rise to confirm
the surface has been set. Select the go to home button.
.
© 2018 Vision Engraving & Routing Systems