Vision Phoenix 1212 S5 User Manual page 10

10 Vision Phoenix 1212 S5 User Manual
Do not try to stop the spindle manually with your hands or other devices. Failure to comply
with these instructions may result in serious personal injury!
Ø Never leave the machine unattended.
Ø Press any Emergency switch to stop the machine immediately. Be familiar with the location
of all emergency stop switches.
Ø Make sure workpiece is properly fastened to table before starting the job.
Ø Turn on the vacuum table (if equipped) or make sure clamps and other fixtures are fastened.
If workpiece moves during operation you can damage the machine, the workpiece, and
serious personal injury may occur to the operator.
Ø Only use the machine and its attachments for the applications they were designed for.
Forcing the machine or its attachments to do work it was not intended to do may cause
permanent damage to the machine and serious injury may occur to the operator. If there are
any questions about the abilities of your machine, please call the Vision technical support
team at 602-439-0600.
Ø Do not force the machine to work at excessive speeds. The machine will work safely under
normal speeds which are material and application dependent. Using excessive speeds may
damage tooling, material, the machine, and may cause serious injury.
Ø Do not power on the machine when servicing.
Ø Do not power on the machine when installing or replacing parts and/or accessories.
Ø Turn power to the machine OFF when not in use.
Ø Perform the required maintenance at the recommended intervals.
Ø Use the general maintenance guidlines to properly maintain your machine.
Ø A disciplined approach to preventative maintenance can extend the useful life of any machine,
improve cut quality, and reduce repair costs. Keep records of what and when you perform
maintenance duties.
© 2018 Vision Engraving & Routing Systems