Vision Phoenix 1212 S5 User Manual page 73

Step by Step Operation 73
to the sign. All of these adjustments are available when entering text in the Frame Text Compose mode.
Once the file has been set up, select the Engrave Icon from the left toolbar, click on the Tool Setup icon
and from the Materials selection drop down list, select Engravers Plastic(Engraving), then click on OK. In
the picture below, the Cut Toolbox shows that the Vacuum, Prox, Dry Run, and Spindle are all enabled.
Since this is the second example job, sending a Dry Run job to the engraver is suggested.
© 2018 Vision Engraving & Routing Systems