Vision Phoenix 1212 S5 User Manual page 129

Maintenance 129
The X and Y-Axis linear rails should be wiped down with a clean, dry cloth each week and a few drops of
machine oil (such as 3-in-1 Oil) should be applied to the rail surfaces. Spread the oil over the rails using
a cotton swap or your finger. Lubrication frequency will depend on usage and the types of materials being
engraved.
The Z-Axis linear bearing should be wiped down with a clean, dry cloth every week and a few drops of
machine oil (such as 3-in-1 Oil) should be applied to the rail surfaces as per above.
(Carriage and Side Covers Removed for Clarity)
© 2018 Vision Engraving & Routing Systems