Slot Table Removal/Height Adjustment - Vision Phoenix 1212 S5 User Manual

General Information 17
2.3 T-Slot Table Removal/Height Adjustment
If using the Deep Vise accessory, the T-Slot Table will need to be removed. Loosen the 4 Allen Head
bolts holding the table to the stantions/risers and lift the table out of the machine.
Mount the vise using the threaded holes in the table baseplate.
To adjust the height of the T- Slot Table, the standard 2 3/4 inch Stantions/Risers can be removed and
replaced with optional 2 inch risers. Remove the T-Slot Table and remove each riser. There are machined
flat surfaces on the top of each riser to allow removal/installation with an open end wrench.
NOTE: Be sure to label each riser with its location, so that when the risers are re-installed, the table is
properly leveled.
© 2018 Vision Engraving & Routing Systems