Vision Phoenix 1212 S5 User Manual page 51

The Front Panel 51
Go to Location Screen
The Go to Location screen is used to move the spindle to a specific location on the engraving area.
Press the X button and the X display will turn red. Then type in the location using the number pad. Press
the Y button and type in the location using the number pad. Then press the green check mark. The
spindle will move to that exact location.
Measure Feature
Press plate size, then measure in Vision software. The machine goes into measure mode, the laser
pointer turns on, and the machine screen will change to the Measure screen shown below. Using the X
and Y jog buttons on this screen, jog the laser pointer to the top left corner of the desired engraving area
and press the green check (select) mark. Using the same X and Y jog keys, jog the laser pointer to the
bottom right corner of the desired engraving area and press the green (select) check mark. The software
automatically creates a plate size in this bounding area.
© 2018 Vision Engraving & Routing Systems