DURKOPP ADLER 610-10 Service Instructions Manual page 63

Individual settings
To set the looper thread take-up:
1. Loosen the screws (6).
2. Move the looper thread take-up (7):
Important
Fig. 46: Setting the looper thread quantity (2)
(1) - Thread bobbin case retainer
(2) - Thread bobbin case retainer:
Ensure that the height of the looper thread take-up (7) is not changed! The
hole (3) must always remain above the bar (2) of the thread bobbin case
retainer (1).
3. Tighten the screws (6).
Service Instructions 610-10/630-10 - 01.0 - 12/2016
• tighter seam = move the front edge (4) towards the 0 on the scale (5)
• more elastic seam = move the front edge (4) towards the 5 on the
scale (5)
①
③
②
Lower bar
(3) - Looper thread take-up: Hole for thread guide
(7) - Looper thread take-up
⑦
61